판매용 중고 CINCINNATI Bar Type #137826

Horizontal milling machine Bar type Fixed Work, Traveling Spindle The Spindle assembly consists of a 6” diameter bar coaxial with a 12” outer Spindle inside a 14” Quill The outer Spindle moves with the Quill in the “Z” axis The Bar travels independently of the Quill supported by sleeve bearings, and also moves in the “Z” axis X (Horizontal) Axis travel = 312” (26') (Plus 2” overtravel at each end) Y (Vertical) Axis travel = 84” (7') (Plus 2” overtravel at each end) Z Axis travel = 36” (3') (Plus 1” overtravel at each end) Feed rates: Manual Mode – X,Y,Z, = 0.5-150 I.P.M. Numerical Control Mode – X,Y,Z, = 0 -150 I.P.M. Slew Mode – X,Y,Z, = 150 I.P.M. Spindle Speed 18 – 1800 R.P.M. Bar Nose Dia = 6” Bar Travel (Z Axis) 36” Intermediate Spindle Dia. = 11.906” Quill Dia = 16.500” Quill Travel (Z Axis) = 36” Ranges: Intermediate Spindle face to Carrier face = 1.500” – 37.500” Bar face to Carrier face = 5” – 41” Bar centerline to top of work table = Max 78” Bar face (retracted) to edge of work table = Min 7” Work mount angle plates: 9’ high x 9’ wide vertical face with T-Slots x 4’ deep base plate 6’ high x 6’ wide vertical face with T-Slots x 4’ deep base plate Work Tables: 8’ Deep x 10’ wide T-slotted – pit mounted 6’ Deep x 10’ wide T-slotted on 8’ x 10’ base – surface mounted Numerical Control: Delta Tau retrofit 1995 PMAC Operating System with Paradym 3.1 Industrial Control Software. De-installed 2001.