판매용 중고 VAC AERO VAH 1220 HV-2 #9094652

Vacuum diffusion furnace Hydrogen Partial Pressure Equipped: Other atmospheres also acceptable, N or Ar Vacuum System Roughing Pump: Edwards E2M80 Diffusion Pump: Varian, VHS6 Holding Pump: Varian, DS102 Gas Quench System Blower: VAC-AERO, 10 HP Turbine, 600 cfm, 2 bar Heat X: CS 600 Hot Zone: Operating Temperature: 1000°F - 2400°F Max. Clean-up Temperature: 2450°F, 10 Minutes Max Uniformity: As per ASM 2750C Maximum Weight: 60 lbs at 2400°F Power Supply: 35 KVA Hunterdon V.R.T. High purity graphite felt insulation Graphoil hot face Molybdenum heating elements Controls: Programmer: Honyewell DCP-551 O.T. Safety: Honeywell UDC 3300, Type S T/C Vacuum Gauge: Edwards Model AGC Low Vacuum and Partial Pressure use convectron T/C gauges High Vacuum uses Active Inverted Magnetron (Cold Cathode ionization) Datalogger: Honeywell DPR-250 Type S and K T/C and vacuum gauges mentioned above Channels 1-9 – Type K Load T/Cs 13 – Type S Controller T/C 14 – Type S Overtemperature T/C 15 – Tank Vacuum Gauge #1 16 – Tank Vacuum Gauge #2 17 - Type K Roughing Pump Oil 18 – Type K Diffusion Pump Oil 19 – Type K Water Inlet 20 – Type K Heat Exchanger Outlet 21-24 – Type K Load T/Cs in DEV Physical Parameters Furnace Control Cabinet: 30” Width x 30” Length x 84” Height Vacuum System: 126” Length x 75” Width x 95” Height Transformers (2): 25” Width x 25” Length x 25” Height Cooling system not included 460 V, 3 PH, 60 Hz 1998 vintage.